If some of you have read the wanted forum, i'm after a new set of alloys, after an incident with the kerb, involving a dick in a beamer. It's nice and bumpy now, is it possible to mess up anything else by kerbing it? like bending driveshafts or other horrible things...

your tracking may be out sligtly, if was when i hit a kurb doing about 40, cos some morinic w*nker in a merc wouldn't move over to his side of the road!!

You'll definately want to get your alignment checked. It all depends on how hard you hist the kerb. Last time I did that, I did a really good job, and bent the left front shock and the control arm ..... Best bet is to start off at a decent alignment place, and they'll check it all out for you ...

It still goes straight when the steering wheel is dead centre, just as it used too. I suspect the wheel is just buggered, i'll post a pic later, its quite funny

I'm sure it's hilarious ......