Iv'e only had my car about a month and already the windows are getitng 'ecthed' by the pillerless windows when they go up and down(94 - 98 BA)


how can this be adjusted if at all?

cheers

do u mean on the actual face of the window? my drivers window is scratched, the rubber bit on the outside that it slides on because it has gone hard from ware and tare.

Neverly every 'f i've seen has etched windows at the front near the wing mirror. Just a bad design fault that one!

yeah i woundered about that, are well.. mine doesnt seem to sit right sometimes under the roof and leaves a howling draft through it on the roads... that another bad design or just me shutting the door to hard?

Dan G

managed to get some photos up on the site under "poor fitting windows" of adjustments that might make the window wind up to the right height apologies for the size - (is bigger always better?)

Yeah mine have those external etches aswell, do you reckon they would come up really obvious if if was to tint the windows, i was hoping on getting them done but not in the humour of spending lots to replace the glass aswell.