Ok so I now have a genuine Mazda near side haed lamp . But the dipped beam looks too low compard to the off side lamp . I've printed off the light set up page of the front of the site, but I'm still none the wiser. I've had a look a t the rear of the lamp and can confirm that there are several cross head screws. Which one to pull the beam up. Everything else sems OK at the mo.

Park your car aiming towards a wall in the dusk - about 3m back.

Get a screw driver, and play with the screws.

Two will adjust the headlight, the other two will adjust the dip beam.

On each, one is horizontal adjustment, the other is vertical.

You'll soon get a feel of what does what - then just match it on the wall to the height of the beam for the correct one.

If that fails - buy a torch

... and have a look on the main web site.

[url]http://www.club323f.com/ba/tuning/lightsetup/lightsetup.php[/url]


Mark

So it's a case of just screwing the 'low beam' up untill at the right hight.

Thanks for the relpies.

You can 'screw it up' if you like!!!!

But you should find it's real easy to do

Job done. Screwed the adjuster down and all sorted. EASY PEASY JOB!!!

hi stuart,

i'm in search of a new genuine mazda o/s headlamp. do you mind telling where you got yours and how much it cost?

cheers
gj

Mine was done on my dealer warranty. But it cost £265. But if you give this guy a call

Carl at Jappart 01642 672255, you'll pay £130 inc delivery and VAT. The plus point is £££'s cheaper then Mazda and is a genuine OE part.