Hey guys

I'm half-way through installing white dials in my astina and ran into a prob. Well new dials have a hole where the little stopper pin goes, the one the needle rests on at 0 revs or 0 kph.

But, how do i take the stopper pins out of the old dials and get them into the new ones. You can't really just pull it out, I tried and nearly broke the whole thing off.

Any advice???

http://www.maz323f.co.uk/tuning/whitedi ... edials.php


This may help?!

ttfn

Phil[/url]

if you bought ur white dials from lockwood then u should have gotten stopper pins with them and if not then contact them. and as for the old ones, they are stuck on their for good so i wouldnt try to pull them off anymore.

Yeah Lockwood dials come with push fit needles that 'push fit' into the holes - beleive it or not!

You'll never get the originals out!