| Club323F http://www.club323f.com/forum/ |
|
| Backfiring Exhaust! Does yours? http://www.club323f.com/forum/viewtopic.php?f=18&t=5634 |
Page 1 of 1 |
| Author: | QBall [ Fri Oct 07, 2005 9:02 am ] |
| Post subject: | Backfiring Exhaust! Does yours? |
For a while now my car has been backfiring. I do have a Ø50mm (2" est.) exhaust system with the standard maifold. Is my 180se Astina's Fuel mixture too rich? My timing is set on 11deg advanced? Is this serious?HELP! |
|
| Author: | Smotter [ Fri Oct 07, 2005 9:49 am ] |
| Post subject: | |
Does it backfire all the time, or just occasionally ? Mine often gives a very satisfying "POP" when I'm thrashing her and I drop the clutch and change into the next gear ...
|
|
| Author: | jh1806 [ Fri Oct 07, 2005 10:31 am ] |
| Post subject: | |
Mine is currently broke - hole in the middle box - that pops every now and again - it's little amounts of un-burnt fuel igniting from the heat i think... |
|
| Author: | QBall [ Fri Oct 07, 2005 10:54 am ] |
| Post subject: | |
Only occasionally, but if I rev her while in neutral the exhaust gives of small little backfires. |
|
| Author: | fil_auto [ Fri Oct 07, 2005 11:03 am ] |
| Post subject: | |
Could be down fuel mixture. Do you have an FSE PBV? I know when I fitted mine, I had the mixture a little high on the fuel side - that made the exhaust pop quite alot! L8rs....... #;o) |
|
| Author: | QBall [ Fri Oct 07, 2005 11:18 am ] |
| Post subject: | |
[quote]Do you have an FSE PBV? [/quote] Mind me for asking, but what does the above stand for? |
|
| Author: | fil_auto [ Fri Oct 07, 2005 11:22 am ] |
| Post subject: | |
Apols! I almost knew that was coming! Anyways, stands for Power Boost Valve. The FSE is an adjustable fuel pressure regulator that replacees the standard un-adjustable unit! http://www.club323f.com/ba/tuning/fse/fse_fitting.php ttfn Phil |
|
| Author: | QBall [ Fri Oct 07, 2005 11:32 am ] |
| Post subject: | |
Nope! Have none of them fitted. Maybe I should take my car to get the CO mixture checked? |
|
| Author: | Smotter [ Fri Oct 07, 2005 2:02 pm ] |
| Post subject: | |
Rather get a Unichip fitted, and get the mixture dead right across the rev range ... |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|