Thanks Stuart.
You're best off getting the Mazda one as there are so many different materials for O'rings. You'd have to know your onions to get the right one otherwise
Mark
| Club323F http://www.club323f.com/forum/ |
|
| 'O' ring on the dizzy measurements. http://www.club323f.com/forum/viewtopic.php?f=18&t=5062 |
Page 1 of 1 |
| Author: | Stuart McB [ Fri Aug 26, 2005 4:21 pm ] |
| Post subject: | 'O' ring on the dizzy measurements. |
Just replaced the 'O' ring oil seal on my Ba's dizzy. Used the instructions from a previous post by Mark T and smotter. Any how the seal cost a mere £1.83 from Mazda but if you want to source your own the diamentions are, Internal bore 38mm External diameter 44mm Thickness of the seal (looking edge on) 4mm Thickness of the seal (looking at it from the front ) 3mm The whole job took no more that 30mins. |
|
| Author: | Mark.T [ Sat Aug 27, 2005 11:13 am ] |
| Post subject: | |
Thanks Stuart. You're best off getting the Mazda one as there are so many different materials for O'rings. You'd have to know your onions to get the right one otherwise
Mark |
|
| Author: | Stuart McB [ Sun Aug 28, 2005 11:45 am ] |
| Post subject: | |
Not wrong mate. There not rubber any more. (Hmmm rubber)  . Had a look on a few site that sell seals and 'O' rings. As you say best to spend the £1.83 and save the hassel.
|
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|