| Club323F http://www.club323f.com/forum/ |
|
| Adjusting Electric Windows on 323F!!! http://www.club323f.com/forum/viewtopic.php?f=18&t=4385 |
Page 1 of 1 |
| Author: | pk1 [ Mon Jul 11, 2005 5:11 pm ] |
| Post subject: | Adjusting Electric Windows on 323F!!! |
Iv'e only had my car about a month and already the windows are getitng 'ecthed' by the pillerless windows when they go up and down(94 - 98 BA) how can this be adjusted if at all? cheers |
|
| Author: | zzoobb [ Tue Jul 12, 2005 5:47 am ] |
| Post subject: | |
do u mean on the actual face of the window? my drivers window is scratched, the rubber bit on the outside that it slides on because it has gone hard from ware and tare. |
|
| Author: | Dragon Rob [ Tue Jul 12, 2005 7:19 am ] |
| Post subject: | |
Neverly every 'f i've seen has etched windows at the front near the wing mirror. Just a bad design fault that one! |
|
| Author: | DanG [ Tue Jul 12, 2005 10:48 am ] |
| Post subject: | |
yeah i woundered about that, are well.. mine doesnt seem to sit right sometimes under the roof and leaves a howling draft through it on the roads... that another bad design or just me shutting the door to hard? |
|
| Author: | dhumpherys [ Tue Jul 12, 2005 1:26 pm ] |
| Post subject: | |
Dan G managed to get some photos up on the site under "poor fitting windows" of adjustments that might make the window wind up to the right height apologies for the size - (is bigger always better?) |
|
| Author: | fixdemfones [ Tue Jul 12, 2005 7:39 pm ] |
| Post subject: | |
Yeah mine have those external etches aswell, do you reckon they would come up really obvious if if was to tint the windows, i was hoping on getting them done but not in the humour of spending lots to replace the glass aswell. |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|