does anyone know how the rear washer is connected? i bought my 95 astina a couple of months ago (so am a bit of a newbie ) but the rear washer doesn't work. i've tried that "poke a needle in the hole" tip, but still no spray
the front washers work fine tho, so i don't think its a problem with the reservoir (it's only the one reservoir right?? ). the rear wiper works so i would think the switch stalk is ok... not too sure where to go from here...
thanks for any help

if you open the boot and take up the carpet covering to the right if you look you will see a washer reservoir...

just have a look around the boot you will see it, make sure its topped up...

doh... thanks for that :P
... but... i topped it up but still no spray...

i can hear the pump going, so i don't think that has conked out... so i'm thinking it might be a blockage or leak?

does anyone know how the tubing is routed? and how to go about pulling it out to have a look at...

thanks for any help

i had the same problem with the front washers in the winter, i didn't top them up for ages and when i did nothing happened! i guessed it was just like air in the pipe or something!

cos after a while it started working again...

...etee, here is a Scan I have done showing you the Route of the Rear Washer Piping...

http://uk.groups.yahoo.com/group/mazda3 ... %20Piping/

V6GREG.

thanks for the scan i'll give it a try when i find some time and let you know how i go...